Konica Minolta 7222 User Manual page 98

Touch STAPLE twice to display the Staple Position Selection popup menu.
Select the desired staple position, then touch OK to restore the Output Mode popup
menu.
4.
Touch OK to restore the Basic Screen.
The selected staple position icon will be displayed in the OUTPUT icon area.
5.
Select additional copy conditions, as desired.
6.
Enter the desired print quantity from the control panel keypad.
See p. 10-3 to be sure that the finisher capacity is not exceeded.
7.
Position original(s).
See p. 3-2 to p. 3-6 for details on positioning originals.
8.
Press [START].
Press [STOP] to suspend the scanning or printing job.
• Finisher FS-113 primary (main) tray gradually goes down while printed
• Finisher FS-114 trays gradually go up/down while printed materials
When the finisher exit tray capacity is exceeded due to the print
quantity selected, remove the copied sets as they exit; otherwise,
mishandled paper will occur.
3-40
Stapling Output Copies (Staple) (continued)
materials output. DO NOT allow any object to interfere with the operation
of the tray on the left side of the finisher, as any interference may cause
damage to the finisher.
output, depending on the tray selected. With SK-114 Saddle kit, the
operation of the trays become greater. DO NOT allow any object to
interfere with the tray operation on the left side of the finisher, as any
interference may cause damage to the finisher.