Konica Minolta 7222 User Manual page 113

If the copy result is satisfactory, proceed to step 6.
If any setting changes are required, proceed to the next step.
If the desired selection cannot be changed, press [STOP] to delete all the
data in memory, then press [AUTO RESET] to restart the job setting.
4.
Touch EXIT (or press [CHECK]) to return to the Basic Screen.
Change the settings, as required.
5.
Repeat steps 3 to 4 until the copy result becomes satisfactory.
6.
Change the print quantity, as required.
Proof copy can be performed as needed, until the print quantity amount on
the Basic Screen reaches zero.
If required, change the print quantity on the Basic Screen.
7.
Press [START].
If the print quantity is not changed, the copier will output the rest, except the sample
sets.
When the finisher / paper exit / inner tray capacity is exceeded due
to the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
Making Sample Copy (Proof Copy) (continued)
4
Helpful
Functions
Proof Copy
Check Mode
Interrupt
Mode
Job Memory
Help Mode
4-3