Changing Your User Function Settings; Dial Parameter Settings; Dial Parameter Settings List - Konica Minolta FAX 9820 User Manual

Table of Contents

Advertisement

HOME
20 ECM FUNCTION: The error correction mode
function may help your machine improve commu-
nication in areas where telephone line conditions
are marginal. See the Troubleshooting section of
this User's Guide for other suggestions if you have
communication problems. Available settings are
ON (default) and OFF.
21 REMOTE DIAGNOSIS: The remote diagnos-
tics feature allows a service person remotely to
dial and service your machine. Available settings
are ON and OFF (default).
22
PC/FAX SWITCH: This function is active
only when the optional PC interface is installed
and your machine is set to the PC Fax answering
mode. In that case, incoming faxes are saved di-
rectly to the PC's disk without being printed. If the
PC is turned off or not functioning, the machine
acts as a stand-alone fax machine and prints in-
coming faxes when this PC/FAX SWITCH function
is set to ON (default). If this function is set to
OFF, the machine will not accept incoming faxes
when the PC is turned off or not functioning.
23 ONE TOUCH PARAM: This function allows
you to activate the Echo Protection feature for a
specific One Touch key, without changing the nor-
mal settings. Echo Protection can improve com-
munication with a location in a noisy telephone
area. For instructions on changing One Touch Param-
eters settings for a One Touch key, see page 31.
1
Press the Select Function key.
2
Press the 9/User Program One Touch key.
The display shows 1:FUNC. PROGRAMMING.
Press the Yes 3 key. The display shows FUNC-
3
TION NO. [ ].
4
Using the numeric keypad, enter the 2-digit number
of the function you want to change. The display
shows the name of the selected function.
5
Repeatedly press the No
want appears in the display.
Note: If you are changing the TX MODE DEFAULT set-
tings, the new settings appear on the lights above the
Yes 3 and the No 4 keys
Press the Yes 3 key to confirm your selection. The
6
name of the next function setting appears in the
display.
7
Press the Select Function key to finish.
4
key until the setting you

Advertisement

Table of Contents
loading

Table of Contents