Initial Steps . . .
3.3
Checking Copier Settings
Check the copier settings before starting a complex copy cycle.
1
Press the [MODE CHECK] key on
the control panel.
An overview of the current copier
settings is shown.
only if necessary
2
Touch a key to change the
corresponding setting.
3
Press [EXIT] to confirm the copier
settings.
The basic settings are
shown again.
3.4
Entering the Number of Copies
Input the number of copy sets that you wish to make from your original.
§
Touch the corresponding keys on
the numeric keypad.
The number of copies is shown on
the touch screen in the upper right-
hand corner.
?
Did you enter an incorrect
number?
§
Press the [C] key on the control
panel. Enter the number of
copies again.
Di200
3
3-5