Table of Contents
Advertisement
Initial Steps . . .
4.6
Stopping the Copy Process
Stop a copy process to prevent further output of faulty copies.
Press the STOP Key on the Control Panel of the copier.
Ü
The copy process is stopped. The number of copies shown on the
information display is set to 1. The other settings are retained.
4.7
Resetting the Copier to Default Settings
Reset the copier to its default settings to start a new copy process (the
stored zoom factors and programs are retained).
Press the RESET Key on the Control Panel of the copier.
Ü
The copier is reset to its default settings. The number of copies shown
on the information display is set to 1.
4.8
Interrupting the Copy Process
You can interrupt an extensive copy process to deal with an urgent copy
job in between.
Which functions cannot be interrupted?
- 2-sided copying
- sorting, grouping, stapling, punching
- cover sheet
- interleaves
- OHP interleaves
1
Press the INTERRUPT Key on the Control Panel of the copier.
The current copy process is paused.
2
Perform the urgent copy job.
Press the INTERRUPT Key again to continue the interrupted copy
3
process.
Rev. /
Which functions are not available during
an interruption?
- sorting, grouping, stapling, punching
- cover sheet
- interleaves
- OHP interleave
4
4-9
Advertisement
Table of Contents
