Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
11.12
Adjusting the steering head bearing play
11.13
Greasing the steering head bearing
11.14
Removing the start number plate
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No
resting locations should be noticeable.
»
If click positions are noticeable:
–
Adjust the steering head bearing play.
–
Check the steering head bearing and replace if required.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Remove fuel tank breather
–
Loosen screws
–
Loosen screw
–
Loosen and retighten nut
Guideline
Nut, steering stem
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
V00232-12
–
Tighten screw
Guideline
Screw, steering stem
–
Tighten screws
Guideline
Screw, top triple clamp
–
Position fuel tank breather
Finishing work
–
Check play of steering head bearing. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
300669-01
–
Remove screw
–
Unhook the start number plate from the brake line and remove it.
V00203-10
1
.
2
.
3
.
4
.
3
.
2
.
1
.
(
p. 34)
(
p. 35)
1
.
(
p. 37)
p. 31)
p. 31)
M20x1.5
10 Nm (7.4 lbf ft)
M8
20 Nm
(14.8 lbf ft)
M8
20 Nm
(14.8 lbf ft)
p. 36)
p. 31)
37
Advertisement
Table of Contents
