Pata Ide Mode; Sata Port; Onboard Dev Ice; Usb Controller - Albatron PX915PC PRO-G User Manual

Disabled Disable on-chip serial ATA. No Serial ATA devices installed.
Auto(default) BIOS will auto-detect the presence of any SATA devices.
2 (or 1) IDE drivers + 4 (or 3) SATA drivers
2 (or 1) IDE drivers + 2 (or 1) SATA drivers (Must connect with SATA1 +3 or with
SA TA2+4)
4 ( or 3 or
2 (or 1) IDE drivers
Combined Mode Windows
devic
simul
This means that you will have one available IDE channel for 2 SATA drives to
use (each IDE channel can support 2 IDE drives). If you were to install all both
IDE drives and 4 SATA drives, you will only see 2 of the SAT
the 2 IDE drives.
Enhanced Mode In this mode, you can use all 6 hard disk drives (including 2 IDE
drives). Note: You cannot use "Enhanced" mode with
only support to install Windows® 2000/ XP if you want to boot from SATA
device. (It's restriction from Microsoft.)
SATA Only S elect this option when you install SATA drives only.

PATA IDE Mode

This item allows you to select an IDE channel for PATA IDE devices. When you install the SATA device(s)
to the SATA1 or 3 or 1+3, this item should be set to channel 1. When you install the device(s) to the
SATA2 or 4 or 2+4, this item should be set to channel 0.
Options: Channel 0 (def ault)、channel 1

SATA Port

This item will display w hich IDE channel w
Options: SATA2, 4 is channel 1
Onboard Dev ice

USB Controller

This option should be enabled if your system has a USB port installed on th
n eed to disable this feature if you add a higher performance controller.
Options: Enabled (defau lt)、Disabled
USB 2.0 Controller
This option should be enabled if your system has a USB 2
will need to disable this feature if you ins
Options: Enable d (default)、Disabled
USB Keyboard Suppor
Enables support for USB attached keyboards. Options: Disabled (default)、Enabled
PX915PC/ PX915GC Series
Combined Mode
2 or 1)SATA drivers
Disabled
®
98/ME can recognize IDE devic
e and therefore you must use this m
ate an IDE device by assuming the role of one IDE channel in the system.
ill be used to the SATA device.
tall a USB 1.1 device.
t
35
Enhanced Mode
SATA only
es but cannot directly recognize an SATA
ode to allow the SATA device to
A drives along with
Windows® 98/ME. It
e system board. You will
.0 device installed on the system board. You
drives and 4 SATA