Auto Punch In / Out Recording - Korg D16 Manual

Auto Punch In - Out Recording:
1. Record - enable Track 2, because you're going to use it for the Auto - Punch procedure (Press the
Track 2 TRACK STATUS key two times, until it lights RED (record status).
2. Reset the song to measure 001.01.000. (Hold the STOP key, then press the REW key once
REHEARSE the Auto-Punch before actually recording it:
1. Press the RHSL (Rehearsal) key (to the right of the REC key). The RHSL key's LED will light GREEN.
2. Press the AUTO PUNCH key. Then press to highlight the AutoPunch:Off button in the display - it will
change to AutoPunch:On, and the AUTO PUNCH key will light. Note that your stored In /Out times are
also displayed on this page.
3. Press the REC key, then press the PLAY key. You'll hear what was previously-recorded on Track 2,
then, at your registered IN point, you can rehearse the AutoPunch-In. Continue speaking, and when the
Counter reaches the registered OUT point, you'll hear the original Track 2 audio again, until two
measures following the Punch-Out location. The Counter will then reset to measure 001.01.000, and
playback will automatically stop.
RECORD the Auto Punch-In Out:
1. Press the RHSL key to turn off the Rehearsal function (unlit).
2. Press the REC key, then press the PLAY key, and record - your new vocal track will be inserted between
the IN and OUT points. The D16 will stop recording and continue playback for two measures following
the Punch-Out location, then playback will stop, and the Counter will reset to measure 001.01.000. (The
Post-Roll time is already set to two measures - more on this "RolTime" function in a moment).
3. Press the AutoPunch:On button in the display, to turn off the Auto Punch function.
4. Press the Track 2 TRACK STATUS key two times, until it lights GREEN (play status).
29
KORG D16 Guide