Storing Locate Points - Korg D16 Manual

Digital recording studio

Hide thumbs Also See for D16:

Table of Contents

Storing Locate Points

Locate points are used to:

- Instantly-move to a registered time location

- Loop playback in / out points

- Set in / out points for auto-punch recording

- Specify locations for track editing

- Set locations for song playback

Use the current song as an example:

1. Press the SONG key, then press the SongSel tab in the display.

2. Press to highlight the Counter (001.01.000) in the display.

3. Rotate the DIAL to the right, until the Counter reaches a position in time where you want to store a locate

point. (Example: Move the Counter position to measure 002.01.000)

4. Press the STORE key, then press the IN / LOC1 key. You've just registered a time location to this locate

key.

Note: For the rest of the exercises in this Section, you'll need to hold the STOP key

and press the REW key to reset the song to the beginning.

KORG D16 Guide

Table of Contents