Working With The Insert Effects - Assigning And Routing - Korg D16 Manual

Work with the Lead Guitar Track:
1. Lower all the Channel Faders to their minimum positions, then press the PLAY key to restart the song.
2. Press the METER / TRACK VIEW key to view the Post Fader mix and...
3. Raise the Track 6 Channel Fader to the "0" position. Listen to the Lead Guitar track - note that some
effect processing was applied to this track when it was originally recorded.
Set Loop Playback for the Track:
1. Press the STOP key, then press the IN / LOC1 key to locate to measure 001.01.000.
2. Press the SONG key, then press to highlight 001.01.000 in the display.
3. Press the FF key once, to advance the Counter to measure 002.01.000.
4. Press the STORE key, then press the IN / LOC1 key, to store the IN point.
5. Now slowly-rotate the DIAL to the right, until the Counter reads 013.01.000.
6. Press the STORE key, then press the OUT / LOC2 key, to set the OUT point. Now you can set Loop
Playback for the song, and concentrate on working with the Insert Effect you'll apply to the track.
7. Press the LOOP key, then press the Loop:Off button in the display to enable Loop Playback (the LOOP
key lights).
8. Press the PLAY key - the track will loop continuously as you work with the next exercises...
Working with the Insert Effects
Assign Insert Effects for Playback and set the Routing:
1. Press the INSERT key, then press the InsAss tab in the display.
2. Press the Popup button to the left of the current Assign: setting in the display, then press to highlight
PlayTrack, and press the OK button in the display. The Assign: setting will indicate "Trk".
49
KORG D16 Guide