Discovery Telecom VoIP2 All Series User Manual page 27

2009
DTT VoIP2All USER MANUAL
Assigning a SIM to Work in a Port at a Specific Time
1. Select a port from the list of the ports in the left.
2. In the 'Type' category, select the form of the timetable: monthly or weekly.
3. In the 'Swapping Type' category, to work by timetable ‐ select 'time table.'
4. Select a SIM from the list of available SIMs at the top. The list is organized by the SIM
Servers. L1 (Local 1) at the top of the list is the port's local SIM (on the board of the
SLAVE card).
5. The top row of the Timetable represents dates and the left column represents hours.
6. Each time slot is for an hour.
7. Left click will select the SIM for this time slot and mark it with it's corresponding number.
8. To un‐select time slots simply click on it again.
9. You are unable to choose a SIM that is already in use at that time in the Gateway.
10. After setting all the needed SIMs, Press 'Save'.
11. Press 'Apply' to activate the changes.
Assigning the SIMs to work for duration of time
The calculation of the units per call is:
Units per call = (Time of the call/ Bill Interval) * Units Per Interval.
1. Go to the SIM settings, If it is a local SIM, it is in the 'Local SIM Settings' tab that in the
'Ports' window. If it is a SIM Server SIM it is in the 'SIM Server Settings' in the 'Virtual SIM'
window.
2. Set this SIM settings:
•
•
•
•
3. Select a port from the list of the ports in the left.
4. In the 'Type' category, select the form of the timetable: monthly or weekly.
5. In the 'Swapping Type' category, to work by call duration ‐ select 'call duration.'
6. Select a SIM from the list of available SIMs at the top. The list is organized by the SIM
Servers. L1 at the top of the list is the onboard SIM on the SLAVE card.
7. The row of the timetable represents dates and the column the order on the list.
VoIP 2 All™ Series: 4 Channel Gateway User Manual
•
'Call Duration' – The SIMs will replaced when thy end their defined calling minutes.
In this mode you set up in the table a list of SIMs, for each SIM in the list you define
amount of calling units to use, each SIM will work for the defined calling minutes
and will replaced with the next SIM on the list.
Bill Interval – The interval of time in seconds for each unit.
Units per Interval – The amount of units for each interval.
Recharge Type – The time to recharge the units. If 'Weekly' then at the end of the
week the SIM initial units will be set. . If 'Monthly' then at the end of the month the
SIM initial units will be set.
Current Balance – The total amount of units for the SIM. It should be set always higher
then 0, recommended to set it to max (9999).
27