Attaching The Filler Panel Covers - IBM 4820 Planning, Installation And Service Manual

Integrated touch pedestal instructions
Figure 2-28. Attaching the filler panel covers
6. See "Tailoring your installation" on page 2-1 and continue with your
SurePOS 720, 740, or 780 directly on system unit: Follow these steps when
installing the integrated touch pedestal onto a SurePOS 720, 740, or 780 without an
integration tray:
1. Remove the rubber plugs in the top cover of the system unit (if not already
2. Install the arm assembly in the box filler panel.
3. Route the cables as described for your 4820 model.
4. Place the arm assembly on the system unit as shown in Figure 2-29 on page
2-24
4820 Planning, Installation and Service Guide
installation.
removed).
a. See the SurePOS 720, 740, and 780 Hardware Service Guide to remove the top
cover.
b. From the inside of the top cover, push the rubber plugs out of the plastic.
c. Reinstall the top cover.
2-25. Insert and tighten the four thumb screws as shown.
Note: The left or right placement of the arm assembly depends upon your
configuration.
January 14, 2005