Installing the IBM 4820
Installing the pedestal
This section describes how to install the distributed, integrated, integrated touch
and free-standing pedestal. Cable routing steps are included.
Distributed pedestal
Follow these instructions for installing the 4820 SurePoint Solution to the
distributed pedestal:
Attaching the distributed pedestal to the counter
The distributed pedestal is available in short (238.2 mm/9.38 inches) and tall (350.6
mm/13.80 inches) versions. Both pedestals bolt to your counter; therefore,
installation is the same. Figure 2-12 shows the mounting order for the tall pedestal.
Figure 2-12. Mounting the distributed pedestal
Follow these steps to attach the distributed pedestal to the counter:
1. Using the template (see Figure B-1 on page B-1) as a guide, mark the screw
2-8
4820 Planning, Installation and Service Guide
hole locations for drilling through the counter. Use 8-mm bit or 5/16-in. bit to
drill the four screw holes.
Note: To route cables through the counter, drill two 2.2-mm (7/8-in.) holes
through the counter. Trim the remaining material between the holes with
a small saw or chisel.
Pedestal
Mounting surface
Metal support bracket
M6 screws
January 14, 2005