IBM 4820 Planning, Installation And Service Manual page 56

Installing the options
Attaching the MSR
Follow these steps to attach the magnetic stripe reader (MSR) to the 4820 SurePoint
Solution:
Figure 2-35. 4820 SurePoint Solution with MSR
1. Remove the MSR/keypad connector cover from the rear of the 4820 by pulling
2. See Figure 2-35.
3. Attach the MSR cable to the MSR connector.
4. Install the new connector cover that shipped with the MSR.
5. Continue with the installation by attaching the pointing device.
2-30
4820 Planning, Installation and Service Guide
on the cover. Discard this connector cover.
v Models 2xx and 5xx: Align the MSR ( 1 ) such that the connectors are
slightly above their matching slots on the 4820. Slide the MSR downward
( 2 ) until it snaps into place.
v All other models: Align the MSR with the edge ( 1 ) of the 4820 so that the
top edge of the 4820 aligns with the top of the keypad. Slide the keypad unit
downward ( 2 ) until it snaps into place.
January 14, 2005
1
2