Placement Of Cable Covers - IBM 4820 Planning, Installation And Service Manual

January 14, 2005
2. Place the 4820 display on the free-standing pedestal. Make sure that the metal
3. Secure the 4820 to the mounting bracket by using four screws.
4. Connect and route the cables to the 4820:
Note: Ensure that you have attached the cables to the appropriate ports in the
5. Install the covers.
Figure 2-19. Placement of cable covers
6. Power On the system unit. See Table 1-5 on page 1-9.
7. Auto adjust your screen for maximum viewing. See "Adjusting the image" on
tabs on the mounting bracket slide into the appropriate slots on the back of the
4820 display.
a. Place the cables in the cable trough.
b. Connect to cables to the appropriate ports on the 4820.
back of the system unit.
a. Attach the cable cover ( 1 ) to the mounting bracket (as shown in
Figure 2-19), snapping the tabs on the sides of the cover into the small holes
on the sides of the mounting bracket.
b. Attach the mounting bracket cover ( 2 ) to the back of the display. Slide the
tabs on the cover into the appropriate slots in the back of the display and
snap into place.
page 2-35.
Free-standing pedestal instructions
2 Mounting bracket cover
1 Cable cover
Chapter 2. Installing the IBM 4820
2-15