Chapter 2. Installing The Ibm 4820; Tailoring Your Installation; Pointing Device - IBM 4820 Planning, Installation And Service Manual

January 14, 2005

Chapter 2. Installing the IBM 4820

This section describes procedures for setting up the 4820 SurePoint Solution.
Unless otherwise indicated, these procedures apply to all models. Be sure to know
your model number, and type of touch technology. See Table 1-1 on page 1-1.

Tailoring your installation

Because of the numerous 4820 Model types, pedestal types, and available options
for the 4820, you must tailor your installation to fit your configuration. This section
provides instructions by pedestal type, and by option. The recommended steps of
installation are:
10. For Models 2xx and 5xx, run the optional IBM Advanced Touchscreen
© Copyright IBM Corp. 1999, 2004
1. Select the pedestal type and route the cables. Refer to Figure 2-1 on page 2-2.
Note: Cable routing is unique for each pedestal and system unit.
2. See to "Installing the options" on page 2-27 and install your optional
hardware to the display in the following order:
a. Keypad/MSR or MSR
b. Pointing device
c. Keylock barrel
3. Connect the cables to the 4820 SurePoint Solution.
4. Install the optional speaker kit (see "Attaching the audio kit" on page 2-32) or
cable cover.
5. Connect the cables to your system unit.
6. Power on the system and the 4820 display. See to "Powering on" on page 2-34
7. Perform an auto adjust to obtain the optimal image. See "Adjusting the
image" on page 2-35.
8. Attach optional button cover, ( see "Installing the optional button cover" on
page 2-46).
9. Install the appropriate touch driver for your 4820 Model number (see Table 1-1
on page 1-1). Touch drivers are available from the IBM Web site:
www.ibm.com/solutions/retail/store. Then click on Support.
Note: For multiple monitor installations (two monitors attached to a single
host, or a 4820 attached to a 4840), any 2xx or 5xx model can run with
any other touch model, however both drivers must be installed.
Configurator to enable the multiple monitor support, beep on touch, and the
blocked beam monitor. See "Features of the IBM Advanced Touch Screen
Configurator" on page 2-45 for additional information.
2-1