Lock Insert And Brass Key - IBM 4820 Planning, Installation And Service Manual

Installing the options
Lock cylinder
Lock insert with
brass key
Figure 2-32. Lock insert and brass key
10. Test the lock to ensure that it operates correctly with the keys.
11. Continue with the install as described in "Attaching the MSR/keypad."
Attaching the MSR/keypad
Follow these steps to attach the MSR/keypad to the 4820 SurePoint Solution:
Figure 2-33. 4820 SurePoint Solution with attached keypad/MSR
1. Remove the MSR/keypad connector cover from the rear of the 4820 by pulling
2. See Figure 2-33.
2-28
4820 Planning, Installation and Service Guide
8. Push the lock insert and brass key fully into the empty lock cylinder.
9. Hold the lock insert in place with your finger and remove the brass key.
upward on the cover. Discard this connector cover.
v Models 2xx and 5xx: Align the MSR/keypad ( 1 ) such that the connectors
are slightly above their matching slots on the 4820. Slide the MSR/keypad
downward ( 2 ) until it snaps into place.
January 14, 2005
1
2