Routing The Power Cable - IBM 4820 Planning, Installation And Service Manual

Integrated pedestal instructions
4. Route the power cable and secure it to the mounting bracket with a cable tie as
Figure 2-22. Routing the power cable
5. Install the covers.
2-18
4820 Planning, Installation and Service Guide
shown in Figure 2-22.
Note: Install the optional audio kit at this time. See "Attaching the audio kit"
on page 2-32.
a. Attach the cable cover to the mounting bracket, snapping the tabs on the
sides of the cover into the small holes on the sides of the mounting bracket.
See 1 in Figure 2-23 on page 2-19.
b. Attach the mounting bracket cover ( 2 ) to the back of the display. Slide
the tabs on the cover into the appropriate slots in the back of the display
and snap into place.
January 14, 2005