Continuity Command; Status Subsystem; [:Event]? Command - Keithley 2010 User Manual

5-54 SCPI Command Reference

:CONTinuity command

:THReshold <n>
[SENSe[1]]:CONTinuity:THReshold <NRf>
Parameters
Query

STATus subsystem

[:EVENt]? command

[:EVENt]?
:STATus:MEASurement[:EVENt]?
:STATus:OPERation[:EVENt]?
:STATus:QUEStionable[:EVENt]?
Description
<NRf> = 1 to 1000
:THReshold?
This command is used to specify the threshold resistance for the continuity
test. Continuity occurs when the measurement is less than or equal to the
specified threshold level.
The STATus subsystem is used to control the status registers of the
Model 2010. The commands in this subsystem are summarized in
These query commands are used to read the event registers. After sending
one of these commands and addressing the Model 2010 to talk, a decimal
value is sent to the computer. The binary equivalent of this value determines
which bits in the appropriate register are set. The event registers are shown
in Figure 5-4, Figure 5-5,
clears the bits in that register.
For example, assume that reading the Measurement Event Register results in
an acquired decimal value of 544. The binary equivalent is
0000001000100000. For this binary value, bits B5 and B9 of the
Measurement Event Register are set.
Specify threshold resistance
Specify threshold in ohms
Query threshold resistance
Read Measurement Event Register
Read Operation Event Register
Read Questionable Event Register
andFigure 5-6. Note that reading an event register
Table 5-7.