Keithley 2010 User Manual page 146

5-8 SCPI Command Reference
Table 5-2 (cont.)
CALCulate command summary
Command
:LIMit 2
:UPPer
[:DATA] <n>
[:DATA]?
:LOWer
[DATA] <n>
[DATA]?
:STATe <b>
:STATe?
:FAIL?
:CLEAR
[:IMMediate]
:AUTO <b>
:AUTO?
:IMMediate
*Note: ON is the *RST default parameter, and OFF is the :SYSTem:PRESet default.
Table 5-3
DISPlay command summary
Command
:DISPlay
[:WINDow[1]]
:TEXT
:DATA <a>
:DATA?
:STATe <b>
:STATe?
:ENABle <b>
:ENABle?
Notes:
1. *RST and :SYSTem:PRESet has no effect on a user defined message. Cycling power cancels all user defined messages.
2. *RST and :SYSTem:PRESet has no effect on the state of the message mode. Cycling power disables (OFF) the message mode.
3. *RST and :SYSTem:PRESet has no effect on the display circuitry. Cycling power enables (ON) the display circuitry.
Description
Path to control LIMIT 2 test:
Path to configure upper limit:
Set upper limit (-100e6 to 100e6).
Query upper limit.
Path to configure lower limit:
Set lower limit (-100e6 to 100e6).
Query lower limit.
Enable or disable limit test.
Query state of limit test.
Query test result (1=pass, 0=fail).
Path to clear failed test:
Clear failed test indication.
Enable or disable auto clear.
Query auto clear.
Re-perform limit tests.
Description
Path to control user text messages.
Define ASCII message "a" (up to 12 characters).
Query text message.
Enable or disable message mode.
Query text message state.
Enable or disable the front panel display.
Query state of the display.
Default
SCPI
parameter
√
√
√
2
√
√
√
-2
√
√
OFF
√
√
√
√
√
ON
√
√
Default
SCPI
parameter
√
√
(Note 1)
√
√
√
(Note 2)
√
√
(Note 3)
√