Scpi Command Subsystems Reference Tables - Keithley 2010 User Manual

5-6 SCPI Command Reference

SCPI command subsystems reference tables

Table 5-2 through Table 5-11
system. The following list includes the SCPI subsystem commands and the
table number where each command is summarized.
CALCulate command summary
DISPlay command summary
FORMat command summary
ROUTe command summary
SENSe command summary
STATus command summary
SYSTem command summary
TRACe command summary
TRIGger command summary
UNIT command summary
Notes:
• Brackets ([ ]) are used to denote optional character sets. These optional
characters do not have to be included in the program message. Do not use
brackets in the program message.
• Angle brackets (< >) are used to indicate parameter type. Do not use angle
brackets in the program message.
• The Boolean parameter (<b>) is used to enable or disable an instrument
operation. 1 or ON enables the operation, and 0 or OFF disables the
operation.
• Upper case characters indicate the short-form version for each command
word.
• Default Parameter — Listed parameters are both the *RST and
:SYSTem:PRESet defaults, unless noted otherwise. Parameter notes are
located at the end of each table.
• SCPI — A checkmark (√) indicates that the command and its parameters
are SCPI confirmed. An unmarked command indicates that it is non-SCPI.
SCPI confirmed commands that use one or more non-SCPI parameters are
explained by notes.
summarize the commands for each SCPI sub-
(Table 5-2)
(Table 5-3)
(Table 5-4)
(Table 5-5)
(Table 5-6)
(Table 5-7)
(Table 5-8)
(Table 5-9)
(Table 5-10)
(Table 5-11)