Ags Menu Maps; Figure 7-2, Ags Ctrl/Meter Menu Map (Section 1) - Magnum Energy ME-ARC50 Owner's Manual

7.2.5

AGS Menu Maps

This section provides the AGS menu maps available from the CTRL, METER, SETUP and TECH but-
tons on your ME-ARC remote.
Note: When applicable, battery voltage defaults and ranges are shown for a 12-volt battery (24-
volt systems multiply by 2; 48-volt systems multiply by 4).
CTRL
03 Gen Control
OFF
P
Set Gen Control
OFF
METER
[Status/Fault]
04 AGS Meters
P
04A AGS Status
[AGS Status]
Available Statuses:
AC In
Gen Cooldown
Gen Warm-up
Manual Run
No Comm
(No AGS present)
Off
Quiet Time
Ready
Press button
Press SELECT
** For this menu map, the arrow denotes the factory default settings

Figure 7-2, AGS CTRL/METER Menu Map (Section 1)

© 2014 Magnum Energy, Inc.
Using an AGS Module: Operation/Monitoring
Set Gen Control
R
ON
Read Only displays
04B DC Volts-AGS
R
14.4 VDC
04E Since GenRun
13 Days
R
04F Since 100%
13 Days
Start Amp
Start Exercise
Start SOC
Start Temp
Start Test
Start Time
Start Topoff
Start VDC
Start 100% SOC
LEGEND
SETUP
04H Gen Exercise
OFF
P
Set Gen Exercise
Days = OFF
= rotate SELECT knob
R
Set Gen Control
R
AUTO
04C Gen Run Time
R
02.2 Hrs
04D AGS Temp
R
77F
04G Hour Meter
R
00013 Hrs
P
Press and hold the SELECT
button for 3 secs to reset
Fault Amp Fault Test
Fault Exercise Fault Time
Fault Gen Run Fault Topoff
Fault MaxRn Fault VDC
Fault SOC Fault 100% SOC
Fault Temp
Menu Button
Menu Heading
Change Settings
Menu Selections
Default/Current
Setting
...
= all screens not included
R
Page 78