Setup - Strong SRT 5001 User Manual

2. With the pq buttons select Auto Scan, press OK to enter the menu.
3. Press the tu buttons to change Scan mode, and use the pq to
highlight Search, press OK to start auto scan.
5.2.2 Channel Scan
1. Use the pq buttons to select Installation, press OK to enter the menu.
2. With the pq buttons to select Channel Scan and press OK to enter
the menu.
3. Use the tu buttons to select one of two Scan Modes – By Channel
and By Frequency.
4. When By Channel is selected use the cursor buttons to select Scan
Band and Channel No. When By Frequency is selected use the cursor
buttons to select Frequency and Bandwidth. Select Network Search
to ON or OFF, highlight Search and press OK to start scan. After
Channels are found, they will be stored and receiver switches to the
first one saved in the list.
5.2.3 Antenna Setting
1. Press MENU to enter main menu.
2. Use the pq buttons to select Installation, press OK to enter the menu.
3. With the pq buttons select Antenna setting and press OK to enter.
4. Press the tu buttons to change setting. If On is selected, the receiver
will provide 5 V antenna power (for active antennas).
5. Press EXIT button to exit.
5.2.4 LCN Mode
If LCN (Logical Channel Number) is activated and LCN signal is provided by
operator, then channels will be stored at operator defined order. You can activate/
deactivate the LCN function by setting the "LCN Mode" to ON/OFF.

5.3 Setup

This menu allows you to set OSD Language, TV System, Region and Time, Timer
Setting, OSD Setting and Parental Lock.
1. Press pq buttons to highlight desired menu and press OK button
to enter the setting menus. Then press pq buttons to select desired
item. Settings can be changed by pressing tu buttons. You can get
better overview if press OK first. Now you can select desired setting by
pq buttons and confirm it with OK.
2. Press EXIT button to exit.
10
PART 1 • English