Connection; Connecting To Terrestrial Antenna; Connecting To Tv And Vcr; Connecting To A Digital Audio Amplifier - Strong SRT 5001 User Manual

2.0 CONNECTION

2.1 Connecting to Terrestrial Antenna

To receive the broadcast signal, the terrestrial antenna cable should be connected
to the ANT IN connector at the back of the receiver. (Fig. 1)

2.2 Connecting to TV and VCR

2.3 Connecting to a Digital Audio Amplifier
Connect your Digital Audio Amplifier with the S/PDIF connector on the back of the
receiver (Fig. 2).

3.0 YOUR RECEIVER

3.1 Front Panel

3.2 Rear Panel

1. ANT IN
2. TO TV
3. S/PDIF (Coax.) To connect your receiver to digital audio amplifier.
4. USB
5. TV SCART To connect your receiver with your TV set using a SCART
6. Power Cord Your receiver requires a voltage of 220 – 240 V AC (Auto-

3.3 Remote Control

1. MUTE
2. POWER
3. PAGE+/PAGE- Page up/down
4. RECALL
5. VOL+/VOL- Volume up/down
6. MENU
6
To connect an antenna for reception of broadcasting signal.
To connect a TV set or to connect an extra receiver.
Connects to USB device
cable.
selectable), 50/60 Hz ± 5 %. Make sure to check the power
specification before connecting your receiver to the
wall outlet.
Turns the receiver On/Standby
Mutes audio output of the receiver
Back to previous shown channel
Opens the main menu/In menu you will get one step back
PART 1 • English
Fig. 3
Fig. 4
Fig. 5