Troubleshooting - Strong SRT 8105 ECO User Manual

8.0 TROUblESHOOTIng

There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline. Do NOT try to open or disassemble the receiver. It may cause
a dangerous situation and warranty will be void.
Problem
LED indicator not lit
No signal found
No picture or sound
on TV
Scrambled channel
Message
No response to remote
control
Forgotten PIN code
After moving the receiver
to another room/area
you are no longer able to
receive digital reception
The receiver switches off
automatically.
18
Possible cause
Mains lead unplugged
Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to switch
ON antenna power/external
power
HDMI is not selected on your TV
or Amplifier or is set to higher
resolution as TV supports
TV is not switched on
Channel is scrambled
Receiver off
Remote not aimed correctly
Front panel obstructed
Remote batteries exhausted
Antenna signals are too weak
Auto Standby function enabled.
PART 1 • English
What to do
Check mains plug
Check aerial lead
Check aerial
Check with dealer
Switch receiver's Antenna Power
ON/connect external power
Switch to correct TV input
Select lower resolution on receiver
Switch TV on
Select alternative channel
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries
Contact local Service Hotline or
send email to our Support via
www.strong.tv
Press the InfO button on remote
2x or 3x to call up signal bars and
adjust antenna for (maximum)
reception
or rescan channels
Disable auto standby. See section
7.3.8 for details.