Timer Setting; Parental Lock; Osd Setting - Strong SRT 8105 ECO User Manual

PART 1 • English
Summer Time:
Date:
Time:

7.3.4 Timer Setting

This menu allows you to set up to 8 timed events for recording or waking up the receiver.
Use p/q to select Timer Setting from the System Setup menu and press Ok to enter.
The receiver will display a list with 8 timers, followed by their respective status. Select the timer you
wish to set or change with p/q and press Ok to proceed.
The timer setup menu will now be displayed.
The following settings are available:
Timer Mode:
Timer Service:
Wakeup Channel:
Wakeup Date:
Wakeup Time:
Duration:
Once all settings are according to your wishes, use p/q to move the highlight to Save and press Ok
to confirm. To quit the timer without saving your settings, move the highlight to Cancel.

7.3.5 Parental lock

This menu allows you to protect the installation menu and/or channels with a password. You can also
enter a new password in the Parental Lock menu.
Use p/q to select Parental Lock from the System Setup menu and press Ok to proceed. You will be
asked to enter your pin code. (DEfAUlT: 0000)
Menu Lock:
Channel Lock:
New Password:
Confirm Password:

7.3.6 OSD Setting

This menu allows you to change settings for: OSD Timeout and OSD Transparency.
OSD timeout:
OSD Transparency:
Load Default OSD Setting:
increasing by half hours progressively. The cities matching the set GMT Offset
are displayed at the bottom of the screen.
Select Off or On to add one hour extra for summer time during the summer.
Date and Time settings are available only when GMT Usage is set to Off. Use
the 0~9 buttons to enter the date. Press EXIT to proceed.
Date and Time settings are available only when GMT Usage is set to Off. Use
the 0~9 buttons to enter the time. Press EXIT to proceed.
Choose between Off (Timer inactive), Once or Daily (Timer will be executed
every day).
Choose between Channel (Timer will wake up the receiver) or Record (Timer
will start to record the scheduled event).
Use t/u to select the channel the timer will wake up with.
Use the 0~9 buttons to input the date for the timed event.
Use the 0~9 buttons to input the desired start time.
Use the 0~9 buttons to input the timer duration.
Locks the installation menu. You can set Menu Lock to On or Off.
Choose between: Off, AGE 4, AGE 5, up to AGE 18. Channels with a parental
rating above the chosen age will be protected with a password (if available in
your local broadcast.)
Enter your new password (4 digits) here.
Re-enter your password here to confirm.
Sets the time after which on screen banners and messages disappear. The
range is 1~10 seconds.
To set the OSD transparency from Off ~ 40% with 10% steps.
Press Ok to clear all OSD settings and reset to default values.
13