Installation - Strong SRT 8105 ECO User Manual

PART 1 • English
7.1.2 Radio Channel list
Basically, the operation of the Radio Channel List is the same as in the TV Channel List. The only
difference is that in Radio Channel List there is no video information, so it will always display the radio
logo at the right preview screen.
7.1.3 Delete all
Use this menu to delete all stored channels. Select Delete All with p/q and press Ok. The receiver
asks you to enter the pin code. (Default pin :0000). In the confirmation window select Yes with t/u
and press Ok to delete or select No to cancel.
WARnIng:

7.2 Installation

7.2.1 Auto Scan
Use p/q to select Installation and press Ok or u to advance.
Select Auto Scan with p/q and press Ok to enter.
Use t/u to toggle between FTA Only Yes or No. When FTA Only is set to Yes, scrambled channels
won't be stored in the channel list. Use p/q to highlight Search. Now press Ok to start auto scan.
The receiver will store all newly found channels in the channel list.
7.2.2 Channel Scan
Use p/q to select Installation, press Ok or u to advance.
Use p/q to select Channel Scan and press Ok to enter.
Use t/u to toggle between available scan modes: By Channel and By Frequency.
If By Channel is selected, use the cursor buttons to select Scan Band and Channel No. If By Frequency
is selected, use the cursor buttons to select Frequency and Bandwidth. Highlight Search and press Ok
to start scanning. Newly found channels will be stored in the channel list.
7.2.3 Aerial Adjustment
Use p/q to select Installation, press Ok or u to advance.
Use p/q to select Aerial Adjustment and press Ok to enter.
Use p/q move the highlight to the setting you wish to alter and use t/u to change values.
The following settings are available:
Antenna Power:
Beeper:
Channel No.:
Press EXIT to leave the Aerial Adjustment screen.
The Delete all function will permanently delete all current channels and all
favourite lists from your receiver, and you are not able to leave the menu until
you search for channels again.
Set to On if you use an active antenna. When set to On, 5 V will be present on
the ANT IN connector of the receiver. Select Off for passive antennas.
Select On for an audible indication of signal reception. Off turns the beeper
off.
Select a channel that is known to carry a broadcast in your region. The Signal
Strength and Signal Quality bars give a visual indication of the reception.
Adjust your antenna to obtain maximum signal strength and quality.
11