Quick Guide To Using Your Receiver; Operation; Changing Channels - Strong SRT 8105 ECO User Manual

PART 1 • English
TIP:

5.0 QUICk gUIDE TO USIng YOUR RECEIvER

We at STRONG understand that you can't wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose the desired channel with the p/q buttons. Alternatively, you can digit the channel number
with the 0~9 buttons on the remote control. Or press Ok in viewing mode to display the channel list.
The volume can be adjusted with the t/u buttons.

6.0 OPERATIOn

Your new receiver is equipped with several features to make watching TV a true pleasure. This paragraph
describes these features. Please also read chapter 7.0 to get familiar with the menu of your receiver.

6.1 Changing channels

Your new receiver is equipped with four ways to change channels.
Via direct access using the 0~9 buttons.
„ „
Via the channel list trough Ok button.
„ „
Via the Pg+ and Pg- keys.
„ „
Via the p/q keys.
„ „
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9 keys on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits
is possible. Just wait a few seconds and your receiver will switch to the selected channel or press Ok
immediately after selecting the channel number.
6.1.2 Channel list
Press Ok in viewing mode to display the Channel List. Use p/q in the Channel List to highlight your
channel of choice and press Ok once to select the highlighted channel. Press Ok again to leave the
Channel List.
TIP:
6.1.3 Using the /
p
p switches to the next channel.
q switches to the previous channel.
Pg+ switches to the next 10 channels.
Pg- switches to the previous 10 channels.
In case the Welcome "Easy install" menu does not appear after switching on
the receiver the first time, reset the receiver to factory settings by pressing the
mEnU button and selecting Load Factory Setting in submenu Tools. (Default
PIN 0000)
Use t/u to toggle between the All Channel list and favourite lists or press
fAv for a list of available favourite lists.
or keys
q
Pg+/Pg-
7