Configuring Http And Https; Figure 5- The Ip Configuration Menu; Figure 6- Enable Web Server Http/Https Service - NTI SERIMUX-SECURE-x Installation And Operation Manual

2. Configure a terminal emulation program, such as HyperTerminal, using the following settings:
bps = 9600
data bits = 8
parity = none
stop bits = 1
flow control = none.
3. Establish a connection to the console port and press Enter to get a command prompt.
4. At the login prompt, log in as admin.
The default password for admin is admin.
The Configuration menu appears.
5. Enter the following to navigate to the IP configuration:
a. 1 for Network configuration
b. 1 for IP configuration
c. The numbers for the individual IP settings.
The following menu is displayed.
6. Press ESC when done to return to the main configuration menu.
7. Enter number 9 to exit and apply changes.
Changes are saved and applied immediately. There is no need to reboot.

Configuring HTTP and HTTPS

By default HTTP and HTTPS are enabled on the SERIMUX device. To modify these settings, do the following:
1. Enter the IP address for the SERIMUX in a web browser's URL.
2. Choose Web server configuration from the Network Configuration heading on the web interface menu.
3. Choose Enabled or Disabled.
4. Set the desired refresh rate for statistics data. The default value is 10 seconds.
5. Choose an authentication method for accessing the web interface. The default is local.
6. To save and apply changes, choose Save & apply.

Figure 5- The IP configuration menu

Figure 6- Enable Web server HTTP/HTTPS service

6