Set Up Auto Report - Sanav MU-201 User Manual

4.7 Set up Auto Report

Use this command to set up the frequency of Auto Report. MU-201 can report according to time interval only or according
to time and distance travelled. If you sent the SMS command as the Example1 below, MU-201 will check the distance
travelled every 300 seconds to see if it has traveled exceeds 100 meters from the last known location. If it does, it will
report. If doesn't, MU-201 will not report. When the MU-201 stays at the same location for 30 minutes (300 seconds x 6
times), it will also report and marked the location as last known location.
Note: You may limit the amount of the Auto reply messages by inputting the digits from 1 to 9998 in the 「total number
of report」field. When you input 9999, the Auto Report Message will not stop unless you define a new Auto Report Setting.
Setup format:#「username」,「Password」,「Function Code」,「intervals (sec)」,「total number of report」, 「distance
interval(m)」, 「stationary detection(times)」,[Time Unit(s/m/h)]*
Example1：#username,0000,6,300,99,100,6,s*
The table 4.7.1 describes the meaning of each segment in the message above.
Text Keyed In SMS
#
username
0000
6
300
99
100
6
s
*
Description
Start sign.
Default ID of MU-201.
If you have changed the Username, please use the updated one.
Default password.
If you have changed the password, please use the updated one.
Mode 6 defines to change the intervals and times of sending-back data
A constant interval of sending data
The amount of 99 messages sent automatically
Distance Interval: when the auto report function is activated, the tracker will take the
current position as the center point, if this value is defined, the tracker will take this distance
as the radius to make a circle. When the tracker exceeds this circle, the alarm report will be
sent to the assigned router. The unit of this function is meter.
Stationary Detection: If this value is defined by 5, the tracker will detect if the tracker
exceeds the circle for 5 times. If the tracker doesn't exceed this circle, the tracker will send
a notice message. The unit is times.
Time Unit as "s" for seconds, "m" for minutes, and "h" for hours.
In this example, we put "300" in constant interval of sending data, so the actual
report will be 300 seconds.
End sign.
18
Minimum 100m.