The Lag Management Screen - ZyXEL Communications GS1900-8 User Manual

Figure 123 Configurat ion > Link Aggregat ion > Global
The following t able describes t he labels in t his screen.
Table 89 Configurat ion > Link Aggregat ion > Global
LABEL
Global
LACP St at e
LACP Syst em
Priorit y
Load Balance
Algorit hm
Apply
Cancel

22.2.2 The LAG Management Screen

Use t his screen t o view LAG m anagem ent set t ings. Click Con figu r a t ion > Lin k Aggr e ga t ion >
LAG M a n a ge m e n t t o open t his screen.
Figure 124 Configurat ion > Link Aggregat ion > LAG Managem ent
Chapter 22 Configuration: Link Aggregation
DESCRIPTION
Select En a ble t o act ivat e t he link aggregat ion cont rol prot ocol.
LACP syst em priorit y is a num ber bet ween 1 and 65,535. The swit ch wit h t he lowest syst em
priorit y ( and lowest port num ber if syst em priorit y is t he sam e) becom es t he LACP " server ".
The LACP " server " cont rols t he operat ion of LACP set up. Ent er a num ber t o set t he priorit y
of an act ive port using Link Aggregat ion Cont rol Prot ocol ( LACP) . The sm aller t he num ber,
t he higher t he priorit y level.
Select t he out going t raffic dist ribut ion t ype. Packet s from t he sam e source and/ or t o t he
sam e dest inat ion are sent over t he sam e link wit hin t he t runk. By default , t he Swit ch uses
t he I P/ M AC Addr e ss dist ribut ion t ype. I f t he Swit ch is behind a rout er, t he packet 's
dest inat ion or source MAC address will be changed. I n t his case, set t he Swit ch t o dist ribut e
t raffic based on it s I P address t o m ake sure port t runking can work properly.
Select M AC Addr e ss t o dist ribut e t raffic based on a com binat ion of t he packet 's source and
dest inat ion MAC addresses.
Select I P/ M AC Addr e ss t o dist ribut e t raffic based on a com binat ion of t he packet 's source
and dest inat ion I P addresses.
Click Apply t o save t he changes.
Click Ca nce l t o discard t he changes.
GS1900 Series User's Guide
130