Moving The Carriage; Installing The Cutter - Kodak 217857-1 Reference Manual

Moving the carriage

When not in use, the ink cartridges rest in the service station at the right side of the
printer. This device seals the inkjets to prevent them from drying out.
➪ ➪ ➪ ➪ ➪
To move the carriage
1 With the power turned on, press the Shortcut button.
2 Press the up or down arrow button until Access Cartridge displays.
3 Press Select. This moves the carriage away from the service station so that you
can install, change, adjust or clean the ink cartridges, change the cutter, or clean
the service station. Do not move the carriage manually as you could damage the
printer.
4 Press Select again to return the cartridges to the service station.

Installing the cutter

A cutter located in the ink cartridge carriage cuts roll media. The printer is shipped with
the cutter installed.
! Be careful when handling the cutter to avoid injury.
! Cutting media with a worn cutter can cause the media to jam and create a ragged cut
line. Replace the cutter to avoid this condition. Do not cut media on the printer with an
external knife, as you could seriously damage the platen and void the warranty.
➪ ➪ ➪ ➪ ➪
To install the cutter
1 Press the Shortcut button.
2 Press the up or down arrow until Access Cartridge is displayed.
3 Press Select. The carriage will move out from the service station.
ENCAD T-200 Reference Guide
® TM
Printer Setup 1-8