Table of Contents
Advertisement
Installing additional memory
The printer ships with 32 MB of DRAM and is upgradable to a maximum of 128 MB,
64 MB per socket. Additional memory helps to free the host computer more quickly.
Acceptable DIMM sizes
Printer memory may be upgraded by installing 72-pin 60 nanosecond (or faster) Micron
EDO DIMMs that are 32 bits wide. (The printer does not use parity bits.)
The printer will accept 32MB, 64MB, or 128MB DIMMs. Recommended DIMMs are
as follows:
32MB MT4LDT464AG-6X
MT4LDT464AG-6
MT4LDT464AG-5X
128MB MT16LD1664AG-6X
MT16LD1664AG-5X
DIMM installation
The DIMMs are located on the MPCB inside the right cover. The MPCB comes with one
32 MB DIMM installed on the board. The following procedures describe how to remove
the right cover, remove any currently installed DIMM(s), install new DIMM(s) and
replace the cover. You will need a #2 Phillips screwdriver to complete the procedures.
! ALWAYS UNPLUG THE POWER CORD BEFORE BEGINNING.
! To avoid static damage to the printer, never touch the circuit board or its components
without first touching the bright metal portions of the printer. Static damage is more
likely when the relative humidity is low. If possible, wear a grounding strap when
touching the circuit board.
64MB MT8LD864AG-6X
MT8LD864AG-5X
A
Advertisement
Table of Contents
