Table of Contents
Advertisement
Loading media
You can use either roll or single sheet media. To ensure straight paper loading and avoid
skewing, be sure to hold the media parallel to the platen. Use the load lines on the platen
as a guide to correctly align the media. Set the media guides to the width of the media.
Be sure to load roll media from the back only as shown in the Installation Sheet. Load
cut sheets from the front of the printer.
!
IMPORTANT! It is very important to use only Encad media with your printer.
Some third party media has been found to generate electrostatic discharge in excess
of 20 KV. Emissions of this level can cause arcing. These conditions can be tempo-
rary or permanent.
!
If your roll media has wrinkled or damaged edges, cut off the damaged part of the
roll prior to loading to prevent the media from jamming in the printer.
➪ ➪ ➪ ➪ ➪
To load media
1
With media positioned at the back or front of the printer (depending on whether it is
sheet or roll, press the Load button. The printer automatically moves the media into
position for printing.
Feed media
➪ ➪ ➪ ➪ ➪
To feed media
1
Press the Shortcut button, then press the up or down arrow until Feed Media
displays.
2
Press Select.
3
Press the up or down arrow until the desired feed direction is displayed, then press
Select.
ENCAD
T-200
Reference Guide
®
TM
Printer Setup 1-7
Advertisement
Table of Contents
