Advanced' / 'Finishing' Settings - Oce TC4 User Manual

'Advanced' / 'Finishing' settings

'Advanced' / 'Finishing' settings
Introduction
The 'Finishing' options displayed depend on the printer available options.
'Additional strips'
You can add a 'Leading strip' or a 'Trailing strip' to correct the length of the output. The
adjustment of the edges changes the output format.
The 'Leading strip' adds a strip at the top of the printout (0 to 400 mm / 0 to 15.74 in).
The 'Trailing strip' adds a strip at the bottom (0 to 400 mm / 0 to 15.74 in).
Note:
The system displays the units ('mm'/'in') defined in the 'User Preferences'.
'Finishing options'
If a folder is declared in the print system, you can check the 'Fold' option.
The system uses the 'Image Properties' to fold the printout, in order to put the legend
on top of the folded packet.
Note:
When the selected media and print settings do not allow the folded output to be delivered
with the legend on top of the folded packet, a warning message is displayed ('The legend
will not be on top of the folded packet.').
The 'Delivery destination' depends on the printer capabilities and on the 'Fold' option.
To take delivery of an unfolded printout, select the 'Top Delivery Tray (TDT)' or the
'External output'/'Lower receiving tray' set at the back of the printer.
When folding is enabled and selected, the printout is automatically sent to the folder.
The 'Delivery destination' is automatically set to 'Folded delivery'.
Note:
Some media types (thick media) cannot be delivered to the 'Top Delivery Tray (TDT)'
or to the folder.
A media from a roll wider than 36 inches cannot be delivered to the folder.
142 Chapter 5 - The Océ Publisher Copy option