Oce TC4 User Manual page 138

'Advanced' / 'Layout' settings
'Adjust alignment':
You can change the alignment of the image on the media.
The reference is the image displayed in the 'Print Preview'. You can immediately check
the effect of the adjustment in the preview.
Activate the option and type in a value:
In the 'Horizontal' field, a positive value shifts the image to the right of media.
A negative is a shift to the left
In the 'Vertical' field, a positive value shifts the image to the top of media.
A negative is a shift to the bottom
You can set this value when you selected a 'Sheet size' as the 'Media size'.
'Add margins around the image'
Note:
By default, the application retrieves and applies the value set on the printer for each file
format ('Add margin around image').
Define whether the image to be printed needs additional margins. The additional margins
compensate for the non-printable area on the media.
If there are no margins (white space) arranged in the print file, select the 'Add margins
around the image' option.
This option adds an additional margin to each side of the print content in order to avoid
cropping.
You can configure the size of these added margins in the printer configuration tool (Océ
Express WebTools): from 3mm (default) up to 5mm (0.12 to 0.19 inch).
It is recommended to select this option when:
the content of the print file covers 100% of the file (no border) and the size of the
image is the same as the size of the selected media.
the content of the print file covers 100% of the file (no border) and the image is
smaller than the selected media.
138 Chapter 5 - The Océ Publisher Copy option