Do An Extended Scan-To-File Job - Oce TC4 User Manual

Do an extended scan-to-file job

Introduction
This section describes a general workflow for an extended scan-to-file job.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the de-
fault value for that setting in the Océ TC4 Power Logic
After you press the start key, the scanner operator panel always shows the job number
and status of the job. A scan-to-file job appears in the selected destination of the 'Scan
jobs' workspace.
How to do an extended scan-to-file job on the Océ TC4
Place the original face down and right aligned.
1.
The scanner takes the original.
[15] Place the original face down and right aligned
Select a template.
2.
Do an extended scan-to-file job
®
controller application.
Chapter 2 - Use the Océ TC4 35