Oce TC4 User Manual page 30

Use the scanner operator panel
A setting that contains two values only, like 'On' or ' Off'.
When you select this setting while the setting was not in focus, the setting becomes
in focus. When you select this setting while the setting was already in focus, the setting
stays in focus and there are no changes.
Change the value of the setting with the left softkey. The value and icon changes.
A setting that contains a list of values, like 'Lighter/darker'.
Define the required value with the scroll wheel. The value and icon changes.
A setting that contains a list of settings, like 'Original type'.
Define the required value with the scroll wheel. The value and icon changes.
Select the next setting of the list of settings with the left softkey.
Note:
You can enter a numeric value with the numeric keys. To enter a negative numeric value,
scroll to a negative value first and than enter the value with the numeric keys.
Select 'Close' with the lower-right softkey.
4.
Repeat from step 4 to define the next setting.
5.
Note:
Use the 'Defaults' option at the lower-left key to set all settings of the job template to
default.
Define job settings with the scroll wheel and scroll-wheel key only
Focus on a job template with the scroll wheel.
1.
A small diamond in front of a template indicates the focus of the scroll wheel.
Select a job template with the scroll-wheel key.
2.
The top 5 settings appear.
Find a setting with the scroll wheel.
3.
A small rectangle in front of a setting name indicates the focus of the scroll wheel.
Select the setting with the scroll-wheel key.
4.
There are several types of settings. The behavior of the scanner operator panel and the
definition of a setting depends on the type of setting you selected. You can select one of
the following types of settings.
A setting that contains two values only, like 'On' or ' Off'.
Change the value of the setting with the scroll-wheel key to change the value of the
setting. The value and icon changes.
A setting that contains a list of values, like 'Lighter/darker'.
Open the setting with the scroll-wheel key.
Define the required value with the scroll wheel. The value and icon changes.
Close the setting with the scroll-wheel key.
30 Chapter 2 - Use the Océ TC4