NEC N8100-1078F User Manual page 228

9-10 Upgrading Your Server
Setting Operation Mode
Configure the operation mode of hard disks installed in the server as listed below.
SATA hard disk drive
Hard Disk
First hard disk
Second hard disk
Third hard disk *
Fourth hard disk *
* Optional SATA RAID controller is required.
SCSI hard disk drive
Hard Disk
First hard disk
Second hard disk
Third hard disk
Fourth hard disk
Fifth hard disk
Sixth hard disk
*1 Optional SCSI controller or RAID controller is required.
*2 Optional SCSI RAID controller and hot-swap hard disk drive cage are required.
Set the SCSI termination to "OFF" for all hard disks. SCSI termination should be set to
"ON" at the end of the internal SCSI cable.
Bay to Install
Disk bay #1
Disk bay #2
Disk bay #3
Disk bay #4
*1
SCSI ID
ID0
ID1
ID2
ID3
*2 ID4
*2
ID5
Start Command
Enable
Enable
Enable
Enable
Enable
Enable
#4
#3
#2
#1
Bay to Install
Disk bay #1 (bottom)
Disk bay #2
Disk bay #3
Disk bay #4
Disk bay #5
Disk bay #6 (top)