Device Info; Load Default - Octave Copy Master II User Manual

Utility

13.4 Device Info

This menu allows you to see information about the devices built inside your
duplicator. That information includes, but is not limited to, manufacturer,
model number, etc.
Utilities
4. Device Info
00 Port 0 [TM100-30]
SAMSUNG SP1604N
01 Port 1 [1.07]
DVD-VDP-MP1
02 Port 2 [1.G0]
_NEC DVD_RW ND-3540

13.5 Load Default

This function will reset all of the options back to manufacturer's default set-
tings. You should only perform this function if your duplicator is acting ab-
normally.
Utilities
5. Load Default
Load Default
Press OK to Continue
Octave Systems Inc.
Use the Up or
lect the Device Info menu and press the
Enter button to enter that menu.
The first information that is shown is the
Hard Dish Drive information (if a HDD
is installed). The Copy Master II uses
several different kinds of Hard Disk
Drives, so the information that you see
might be different. Press the
button to go to the next display.
The next screen shows information
about the Reader drive. Press the
Down button to go to the next display.
The next screen shows information
about the first Writer drive. Press the
Down button to go to the next Writer
drive. Press the
turn to the Utilities menu.
Use the Up or
lect the Load Default menu and press
the Enter button to enter that menu.
Press the Enter button to load the de-
fault parameters or the
to return to the Utilities menu.
Down buttons to se-
Down
ESC to button to re-
Down buttons to se-
ESC to button
61