Operation; Copy; Making Copies - Octave Copy Master II User Manual

Copy

Chapter 2: Operation
This chapter shows each of the menu options and how they are used.
1. Copy
The Copy menu option or the front panel Copy quick key have
two different modes of operation:
Disc to Disc Copy: This option copies the data directly from the master.
■
HDD to Disc Copy: This option copies the master disc to the Hard Disk
■
Drive (HDD) and then makes the copies from the HDD image.
The mode of operation depends on the Master Reading Source that is select-
ed. If the Master Reading Source is set to either Reader Port 1 or Writer
Port 2, the duplicator will default to Disc to Disc Copy mode. If the Master
Reading Source is set to HDD Port 0, the duplicator will default to HDD to
Disc Copy mode.

1.1 Making Copies

This process will copy your master disc on to several blank discs simulta-
neously. Because of the simultaneous nature of this operation, a good condi-
tion master disc and lower recording speed are necessary for high success
rates and good quality duplications.
Load and Copy: This option copies the master disc to the HDD and then
■
makes the copies from the HDD image.
On the Fly: This option copies the contents of the master disc directly
■
onto the blank discs.
Turn on your duplicator and wait until it has booted up. You should see the
following signifying your duplicator is ready:
Copy Master II
1. Copy
Octave Systems Inc.
5.42
Make sure the Master Reading Source is
set to READER. Make sure that your
current Master Reading Source is the
top tray in order to avoid unnecessary
error messages.
To check the Master Reading Source,
use the
navigate to the 8. Select Source screen.
Up or Down buttons to
Copy
21