Table of Contents
Advertisement
the DHCP server is turned off. If you get your IP address automatically, then
when you change from Router to AP/Client/WDS Bridge mode, your PC will
not be able to get IP address from DHCP server anymore. Therefore, you
should set the IP address manually.
====================================================================
Where is the POE port for N.Power?
Question:
The PoE system used for N.Power is 12V Passive PoE. LAN1 is also used
Answer:
as the passive PoE port.
====================================================================
When I use PoE power with USB Storage, why do I get unstable performance
Question:
sometimes?
Please use a 12VDC power adapter that supply more than 1.25A of current.
Answer:
====================================================================
When I connect my PoE switch with N.Power, why doesn't it work?
Question:
The N.Power use a 12V Passive PoE system, it is not the same as the 48V
Answer:
system used by PoE switch. As matter of fact, connect the 48V system to
the N.Power might damage the device!
====================================================================
I thought the N.Power has 30dBm output power, why do I only see 20dBm on
Question:
the Tx Output Power option?
The maximum output power for N.Power at the antenna connector is about
Answer:
1watt (30dBm). However, it is limited to 20dBm in EU and 23dBm in the U.S.
for compliance with regulations. Nevertheless, unlike normal 11n routers
that typically provide less than 15dBm output power in 11n mode, the
N.Power can provides up to 19dBm(EU) and 22dBm(FCC) in 11n mode. It
means greater coverage in 11n mode.
If you are living in countries that allow use of 30dBm output power, you can
change the Regulatory Domain to South America. Please be sure it is legal
in your country, do not use the wrong regulatory domain.
AirLive N.Power User's Manual
10. Frequent Asked Questions
82
Advertisement
Table of Contents
