Associated Client; Advanced Settings - Ovislink N.Power User Manual

Disable: When selected, no MAC address filtering will be performed.
Allow list: When selected, data traffic from only the specified devices in the
table will be allowed in the network.
Deny list: When selected, data traffic from the devices specified in the table
will be denied/discarded by the network.

6.2.6 Associated Client

Wireless Settings -> Associated Client
You can check the wireless clients' status on this table
MAC Address: MAC address of the wireless clients. If you need to find the IP
address, please go to
Power Saving: 0: The power saving mode is off. 1: The power saving mode is on.
Modulation: Show the which MCS level is used in 11n mode
Channel Width: This indicates whether client is using 20MHz or 40MHz channel
wdith.
RSSI (dBm): The signal strength of the client device.
Time (Sec): The connected time of the wireless client.

6.2.7 Advanced Settings

Wireless Settings -> Advance Settings
Channel Width: You can choose 20MHz or 20/40MHz channel width. Choose
20MHz for compliance with laws in some countries. 40MHz offers faster performance
than 20MHz
menu.
Status->Client Table
59
6. AP Mode
AirLive N.Power User's Manual