Calling; Open The Call List; Incoming Call; Outgoing Call - ASCOM d62 Talker User Manual

User Manual
Ascom d62 DECT Handset
6

Calling

6.1

Open the Call List

1 Press "Menu',
2 Select "Calls"
3 Select "Call list".
4 Select a number.
5 Press
dialled. Press "More" and select "Edit number". The 25 last received, dialled or missed
calls are stored in a call list. See
6.2

Incoming Call

The flashing LED, accompanied by a ring signal and/or a vibrating handset, give you notice
of a call. Ring signal and vibrator can be disabled. The calling party's handset number or
name is shown. The name will be shown if the calling party's handset number is stored in
the local phonebook. Press the Off-hook key to answer the call.
Tip: When a headset is connected to the handset, the headset button can be used to answer
the call. In addition, it is possible to configure the headset button with a specific function,
such as post-dial, dial last called number, or dial a predefined number. See Configuration
Manual, Ascom d62 DECT Handset, TD 92639EN for more information.
Other answering methods can also be set in the Settings menu, see
The answering methods are; Automatically and Loudspeaking.
When "Automatically" is enabled, all incoming calls will be connected automatically.
6.2.1 Answer a Call
When the signal sounds press
the call in loudspeaking mode. The name/number of the calling party is displayed if calling
line information is available.
6.2.2 End a Call
Press
the call can also be retrieved from the Calls menu > Call time.
NOTE: Some systems/PBXs require that the handset sends a DTMF in order to end a call. See
the handset's Configuration Manual for more information. This feature is not applicable for
d62 Talker.
6.3

Outgoing Call

6.3.1 Pre-Dial
Enter the number and press
dialling. If needed, you can press the Soft key "Clear" to erase the number. By using the
navigation key it is possible to step and add/delete a digit in the middle of a number.
It is possible to turn on the tone sender in a pre-dialled number by making a long press on
the *-key.
15 June 2012 / Ver. G
.
or the soft key "Call" to dial. The number can be edited before the call is
to answer the call, or press the soft key
to end the call. The duration of the call is shown in the display. The total time of
to get the line. The number is shown on the display while
4.1 Calls on page 18.
TD 92477EN
4.8 Settings on page 23.
to answer
27