Wall-Mounted Bypass Switch Setup - Eaton Powerware 9155 User Manual

WALL-MOUNTED BYPASS SWITCH INSTALLATION

Wall-Mounted Bypass Switch Setup

36
EATON Powerware
To set up the wall-mounted bypass switch:
1. Remove the knockouts in the bottom or side of the bypass switch for AC Line
Input, AC to UPS Input, AC from UPS Output, and AC to the UPS load (see
Figure 24).
2. Mount the bypass switch cabinet to a sturdy surface within sight of the UPS.
You may need to rotate the cabinet 90 degrees to enable operator access to the
bypass switch.
3. Remove the six screws from the bypass switch front cover and remove the
cover (see Figure 24).
4. Remove and discard any packing material from inside the bypass switch.
®
9155 UPS (8–15 kVA) User's Guide
Figure 24. Wall-Mounted Bypass Switch Knockouts
S
164201553 Rev F www.powerware.com