Configuring Network Settings; Configuring Tcp/Ip Settings - HIKVISION Network Camera User Manual

User Manual of Network Camera

6.3 Configuring Network Settings

6.3.1 Configuring TCP/IP Settings

Purpose:
TCP/IP settings must be properly configured before you operate the camera over
network. The camera supports both the IPv4 and IPv6. Both versions may be
configured simultaneously without conflicting to each other, and at least one IP
version should be configured.
Steps:
1. Enter TCP/IP Settings interface:
Configuration > Basic Configuration > Network > TCP/IP
Or Configuration > Advanced Configuration > Network > TCP/IP
2. Configure the basic network settings, including the NIC Type, IPv4 or IPv6 Address,
IPv4 or IPv6 Subnet Mask, IPv4 or IPv6 Default Gateway, MTU settings and
Multicast Address.
Notes:
 The valid value range of MTU is 500 ~ 1500.
 The Multicast sends a stream to the multicast group address and allows multiple
clients to acquire the stream at the same time by requesting a copy from the
multicast group address. Before utilizing this function, you have to enable the
Multicast function of your router.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
TCP/IP Settings
Figure 6-6
37