Configuring Qos Settings - HIKVISION Network Camera User Manual

User Manual of Network Camera
Configuration > Advanced Configuration > Network > 802.1X
2. Check the Enable IEEE 802.1X checkbox to enable the feature.
3. Configure the 802.1X settings, including EAPOL version, user name and
password.
Note: The EAPOL version must be identical with that of the router or the switch.
4. Enter the user name and password to access the server.
5. Click
Note: it will ask for a reboot for the settings to take effect.

6.3.7 Configuring QoS Settings

Purpose:
QoS (Quality of Service) can help solve the network delay and network congestion by
configuring the priority of data sending.
Steps:
Enter the QoS Settings interface:
1.
Configuration >Advanced Configuration > Network > QoS
2. Configure the QoS settings, including video / audio DSCP, event / alarm DSCP and
Management DSCP.
The valid value range of the DSCP is 0-63. The bigger the DSCP value is the higher
the priority is.
Note: DSCP refers to the Differentiated Service Code Point; and the DSCP value is
used in the IP header to indicate the priority of the data.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
802.1X Settings
Figure 6-13
to finish the settings.
QoS Settings
Figure 6-14
43