HIKVISION Network Camera User Manual page 69

User Manual of Network Camera
 To study the wireless alarms, e.g. the access control device, select Wireless
Alarm from the Study drop-down list, and select the device serial number (1-8)
from the drop-down list, and click
wireless alarm device to the camera.
Notes:
 To study the access control device, you can open the door/separate the device to
send the signal.
Configure the Wireless Alarm and PIR Alarm
 Configure the Wireless Alarm
Steps:
(1) Enter the Wireless Alarm Settings interface:
Configuration > Advanced Configuration > Events > Other Alarm
(2) Select the wireless alarm number. This camera supports up to 8 channels of
external wireless alarm input.
(3) Check the checkbox of Enable Wireless Alarm to activate the alarm and define
the alarm name in the Alarm Name field.
(4) Check the checkbox to select the linkage method taken for the wireless alarm.
Audible warning, notify surveillance center, send email, upload to FTP, trigger
channel, trigger alarm output and trigger wireless alarm output are selectable.
Please refer to Step 3 Set the Alarm Actions for Motion Detection in Section
6.6.1.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Study the Wireless Alarm
Figure 6-37
Wireless Alarm Settings
Figure 6-38
; and then send the signal from the
68