Remote Control; Bypassing Sensors Remotely - 2gig Technologies GO!control 2GIG-CNTRL2 Operation And User's Manual

Remote Control

Once you are connected with the system, you will be able to check on its status and remotely control
the major functions. The announcements that the system plays over the telephone do not sound out
of the Control Panel's speaker.
1. After the Control Panel answers, it will ask for your User Code. You have 15 seconds to enter
your User Code using the telephone keys. If you don't enter a valid User Code in 15 seconds,
the system will hang up. For security, if two calls, with two attempts each, to enter a User
Code within fi ve minutes fail to enter a valid code, the system will hang up and not respond to
telephone commands for 30 minutes.
2. After the system has accepted your User Code, it will announce the system status, then
announce the remote command options. The system will wait up to 60 seconds for each
remote command before automatically hanging up. If you already know the remote command
telephone key number, you can enter it before the command announcement fi nishes.
3. Use the telephone keys to command the system:
• Press for system status report
• Press to arm the system in Away Mode
• Press to arm the system in Stay Mode
• Press to disarm the system
• Press to turn on auxiliary output (if used)
• Press to turn off auxiliary output (if used)
• Press to stop system status report
• Press to hang up
• Press to repeat the command menu
When you are fi nished remotely controlling the system, be sure to press

Bypassing Sensors Remotely

When arming the system remotely, if there are open sensors when you try to arm, the system will
announce the current status and ask "To bypass sensors and arm, press pound".
• Press to bypass all open sensors and arm the system.
After the open sensors are bypassed, the system will arm in the selected mode and it will announce
the system status to you.
Remote Control by Telephone
to hang up.
27