Arming To Stay Mode - 2gig Technologies GO!control 2GIG-CNTRL2 Operation And User's Manual

Arming to Stay Mode

Use Stay Mode to arm the system when anyone will be staying home. Stay Mode normally has an
Entry Delay so someone with a User Code can re-enter without causing an alarm.
1. Close all protected perimeter doors and windows before arming.
2. Verify that the
to arm. The SECURITY button and ARM button on the display will also be green when all
sensors are closed.
3. From the Security Screen, or the Menu Screen, press
• If there are any open door or window sensors, the Bypass Screen will appear. Close
all the sensors displayed or press BYPASS ALL to force bypass the displayed
sensors. NOTE: BYPASSED SENSORS WILL NOT BE ABLE TO TRIGGER AN ALARM.
• To bypass sensors, you will need to enter a User Code unless
the installer has set the system for " Quick Bypass".
4. On the Arming Screen, one check box option can be used with Stay Mode.
• If no one is expected to re-enter, the system can be armed without an Entry
Delay. All perimeter doors will trigger the alarm instantly. To arm with all
perimeter doors as instant, un-check the ENTRY DELAY option button.
5. Press STAY to arm the system.
• To arm the system, you may need to enter a User Code if your
installer has turned off the system's " Quick Arming" feature.
6. The system will arm and show the
system is fully armed in the Stay Mode.
The Security Screen
Entry Delay Check Box
button on the Control Panel is lit green indicating that the system is ready
Exit Delay counting down. When the Exit Delay expires, the
Burglary Protection
ARM.
The Arming Screen
Quick Exit Button
11